Every LED on a Linksys wireless range extender has a meaning. If the LED on your device is blinking green, it means everything is on track. In case, the LED is flashing orange, it means your device will give you a hard time with connectivity issues. But, if the LED is showing off the red color, then it’s a clear signal that you’re caught in a big technical mess.
The Linksys router red light issue can occur because of a lot of reasons: improper power supply, unstable Ethernet connection, weak internet connection, ISP at fault, outdated firmware, WiFi interference, technical glitches, etc.
Regardless of why the LED on your extender is blinking red, we can help you get rid of the issue. A little coordination is needed from your end too. All you need to do is, carefully walk through the troubleshooting hacks mentioned in this post.
Resolved: Linksys Extender Red Light Issue
- Reboot Your Linksys Extender
Before you get down to any other troubleshooting hack, reboot your Linksys wireless range extender. Doing so will help you put at least one reason behind the red light issue to rest, i.e. technical glitches.
In order to reboot your Linksys extender, you need to follow these instructions:
- Power off your Linksys range extender and unplug it from its wall socket.
- Wait for a couple of seconds.
- Then, plug your Linksys WiFi extender back into its wall socket and turn it on.
Now, check whether the LED on your device is still blinking red. If it is, continue reading this post.
- Perform Linksys Firmware Update
Updating the firmware of your Linksys extender via http extender linksys com can also help you get rid of the red light issue.
Thus, walk through the guidelines mentioned below and learn how to perform Linksys extender firmware update:
- Switch on your computer.
- Open an updated internet browser.
- In the address field of the internet browser, type the default web or IP address of your Linksys wireless range extender.
- Press the Enter key.
- A login window will appear asking for the default username and password.
- Thus, enter the default login credentials and click the Log In button.
- Once you are on the web-based setup page, click Firmware Upgrade under the Administration option.
If you also want to update the firmware of your router, you need to access its web-based setup page using the Linksys router password and follow the same steps mentioned above.
- Avoid Signal Interference
Make sure that your Linksys wireless range extender as well as your home router are placed away from transmitting appliances, electronic devices, metal objects, and reflexive surfaces.
Apart from that, avoid keeping your devices in corners, near thick concrete walls and utensils containing water.
- Check the Power Supply
Chances are that you have plugged your Linksys wireless range extender into a damaged wall outlet.
To troubleshoot the issue, it is recommended that you either get your wall outlet fixed or plug your extender into another one.
- Verify the Ethernet Connection
If you have used an Ethernet cable to connect your Linksys wireless range extender and your home router, ensure that it is not worn out.
In case it is, consider connecting your devices with the help of a wireless source.
- Reset Your Linksys Extender
Did none of the aforementioned troubleshooting hacks help you resolve the Linksys extender red light issue? If you are nodding your head in yes, then your last hope is to reset your device.
Here’s how you can do that:
- Look for the Reset button located on your Linksys range extender.
- Take an oil pin or a paper clip and use to press the Reset button.
- Wait for a few seconds.
Summing Up
Our post to troubleshoot the Linksys extender red light issue has come to an end here. We hope that after following the hacks mentioned above, you will be able to stop the LED on your device from blinking red.
Liked reading this article? Whether the answer is a yes or no, do leave a word of appreciation in the comment section.